About Pratik Prajapati

Pratik Prajapati · 08-31-2017

I am running latest 9.8.1 code. I need assistance in allowing traffic from lower security level to higher. Below is the config. Interface g0/1nameif insidesecurity-level 100ip address 10.20.5.1 255.255.255.0 standby 10.20.5.2 interface g0/2nameif DMZ...

Pratik Prajapati · 06-30-2016

I have a 3560 switch and have multiple vlans on it. I need to prioritize traffic for vlan 20. How do I go about doing that? It is for AV equipments. I don't have any DSCP values but I am assuming its 46.

Pratik Prajapati · 03-28-2016

I have 3560 switches acting in L3 mode. There are multiple VLAN interfaces defined on it. The switch has ASA as the default gateway. Clients use default respective VLAN interfaces as their Default Gateway. User VLAN is the inside interface on ASA wit...

Pratik Prajapati · 10-20-2015

"For HSRP circuits, it is a requirement that Datacenter use the first 3 available IPs in the routing network. Datacenter must assign 1.1.1.66 to one of our routers.1.1.1.68-1.1.1.70 are the only IPs your company can use on the routing network.The usa...

Pratik Prajapati · 09-15-2015

I have a Server 2012 R2 HyperV cluster with 3 servers and a Cisco 3560 Switch. I am trying to configure trunk between HyperV server and switch ports. Below is what I have.interface Port-channel10 description VM Internet switchport trunk encapsulatio...

Pratik Prajapati · 08-31-2017

Sound dumb but I need help with creating those ACLs. I have tried different ways but haven't been successful.

Pratik Prajapati · 10-24-2015

Hi, Apparently the Datacenter guys gave us the wrong Gateway. I changed the Gateway to 1.1.1.65 from 1.1.1.66 and everything started to work. Thanks for all your help! -Pratik

Pratik Prajapati · 10-24-2015

Below is the config. I tried pinging using both interfaces as source and both are successful. The clients use 2.2.2.129 as gateway. The client machines are Ubuntu. I try pinging the same from them and it doesn't work.version 15.1no service padservice...

Pratik Prajapati · 10-23-2015

Thanks. That worked. Just one small issue now, Clients behind the router with Public IPs are unable to ping anything past the routers. I removed "no ip redirects" and "no ip unreachables" from the interface. Any ideas?

Pratik Prajapati · 10-21-2015

Thats what I thought too. So am I NAT'ng 2.2.2.128/28 to 1.1.1.68? 2.2.2.128/28 are public IPs.

Member Since	‎03-04-2011 07:00 AM
Date Last Visited	‎06-09-2020 07:23 AM
Posts	78

User Statistics

User Activity

Allow traffic from lower security level to higher - ASA 5515

Cisco 3560 - Prioritize traffic for a particular vlan

Routing Issue between 3560 Switch & ASA5515

1941 router HSRP/WAN LAN Setup

NIC Teaming with HyperV

Re: Allow traffic from lower security level to higher - ASA 5515

Hi, Apparently the Datacenter

Below is the config. I tried

Thanks. That worked. Just one

Thats what I thought too. So