Howdy I have created a template in Cisco Prime to RESET the access points model type 1815W who are connected over FlexConnect but even that Cisco Prime output says that the access points have been rebooted, they are not actually rebooting and on the ...
Good day everyone, Do you know if the having the Catalyst 9200 switches as EDGE switches and 3560CX as EXTENDED NODES will work? We tried to connect them but they don't get set up over PnP protocol. Did anyone else encounter the same issues? Tried ...
Hi everyone, Trying to remove a port channel that is not keeping anymore an extended switch and I want to make it an access port but since DNA Center created a port-channel for that extended switch when I try to remove it it returns following error ...
Hello,I have a problem with my router 861w and I don't know from where is this problem. The situation is like this: I have attached a hard drive on one of the Ethernet port of the router and I'm accessing this hard drive thru my laptop which is wirel...
Hello,I have a question for you guys. I set up my cisco 861w in order to get access to Internet at home. Everything was good except that I can't tune it in order to work on wireless N. Can you take a look at my attached configuration in order to...
@patoberli @Scott Fella Opening a TAC helped at the end.The issue was that the WLC was not having a write community defined and the write community was not set under Inventory / Credentials plus, to push a command to reset the AP is not enough to th...
@Scott Fella @patoberli I did the upgrade of the WLC to version 8.5.161.0 and upgrade all the APs to the same version, no luck getting those APs reset by the PI To resume I've done so far : 1815W and 2802 APs: Upgraded to 8.5.161.0 and enabled SSH fo...
@patoberli I'm planning to upgrade the WLC version from 8.5.140 to 8.5.161. I think that the API connection between the WLC and PI is somehow broken and will see if I upgrade the WLC will solve my problem. Keep you posted.
@Scott Fella The idea is to have the possibility to reboot APs from a specific floor, like floor 9 for example. How would I do that using a cli template? Do you have an example to show?
