hi,
We have a setup of 9800 WLC with 1562I outdoor APs. Even when standing next to the AP, the signal is weak (like -55dBm) it should be in the range of -35 to -45 when that close to the AP. Also, checked the power levels, both radios are operating ...
HI,
I am using cisco WLC versino 8.2 with PI 3.0. I have registered the WLC in PI via SNMP and can see it there. However, I cannot see the APs on WLC in PI and PI is showing zero AP count. Any ideas? I am using cisco 3702i AP with module...
I am facing a specific problem regarding voice phone (7925G) with cisco 3700 AP in flex connect with local switching. The RF layer is fine and only voice is present at 5 GHz. Controller version is 7.6. The specific problem is the call from wireless p...
hi if we want to use 4 channels (FCC Domain) on 2.4GHz band, what should be the recommended channels:Option 1: 1,4,7,11Option 2: 1,4,8,11Please advise urgent...Thanks,..
Hi,i have 1260 AP (Autonomous) and i want the clients to connect only at 5GHz MCS rates (802.11n) and i dont want clients connecting at 802.11a data rates. i tried to do this from AP GUI but it says i have to enable at least one data rate from 11a. ...
Thanks for the reply. What you are mentioning regarding software bug affecting Tx levels can be interesting to check. Although the Tx level of both radios is showing power level 1 (max) when we check on WLC.I will check the software version and if an...
yeah it is not weak in general but not acceptable when you are literally standing 1 meter away from the AP and AP radios running on full power. The moment you walk like 15 meter away the signal is below -70 dBm.