are the ports on the switch where the ap's are connected in mode trunk?(802.1q)

in the wcs is the heatmap based upon rf-prediction or measured rf values?

Try first to connect the ap's to the controller, if the found the controller they store the ip addre...

This is the template, it's all executed,even saved. But at the end i got the config failed with rema...

When i use config templates in the wlse the job always fails stating that the following command resu...

I got it working today:you will need omipeek or airopeek and 2 special dll's. Download of dll's and ...

in aironet i`m unable to set a fixed channel in the 5 Ghz (because of eu dfs). However in airespace ...

How much of the performance drops when ap`s are used to do rogue containment? Can I set in the contr...

thnx rob

can somebody post this: "dhcpguideforwindows.pdf" again?thnx

Thnx for the info, any idea when they will release ccxv5 on the cisco abg cards?

Is there any documentation on how to install and configure mfp on clients and controllers?

You can set the mode of an lwapp ap to sniffer and then read the captured data with airopeek/omnipee...