dathaide

Thanks for the reply but won't this configuration work on syn interfaces as wellinterface Multilink1...

yes the wic 1dsu-t1 would be the card to buy. An external csu/dsu add anothe piece of hardware to th...

hi I have seen users use the int virtual template command and also the ppp multilink command (and so...

hiyou can configure whatever encapsulation you want. HDLC (default) ppp or frame relay. I assume you...

hiYou could possibly have a bad slot 2. Your best bet is to contact Cisco

hiI have already tried the above and it did not do it had to reload the router. I am running 12.3.7T...

hiI have seen users use the int virtual template command and also the ppp multilink command to combi...

hiI have two ospf routers connected via a ppp hence no DR or BDR. However on one end i changed the r...

hiWhen doing a show frame-relay pvc xx on my frame relay connection running traffic shaping. I see a...

hiIt is always better to upgrade to newer code. However be sure and read the advisories with each co...

hiWhat about the cabling from the smart jack to the router? Have you checked/replaced themthanks

hiyour best bet would be to open a TAC case. however if you are unable let me know. I did an upgrade...

this is will answer your questionhttp://www.cisco.com/en/US/partner/products/hw/routers/ps341/produc...

hidoes you configuration look something like thisInterface serial 0/0service-module t1 clock source ...

hiYou can use frame-relay ip rtp header-compressionIf you are running voice traffic you can also use...