dathaide

Yes you would probably lose your connection when you put in the no ip address command. Your best bet...

hiThis is what i've come up withaccess-list 101 permit udp any any range 16384 32767 logaccess-list ...

hiI have a 64K microwave line and a 64K sat link from a remote site. If i want voice traffic travers...

hiyoure right eigrp will load balance across equal paths. What you may be seeing a per destination l...

try ebay

hiOn the spoke end are you seeing a loss of neighbor? Have you check with your FR service provider m...

here you gohttp://www.cisco.com/en/US/products/prod_visio_icon_list.html

What is the difference between the PA-MCX-2T/E1 card and the PA-VXB-2T/E1 card.Can you connect your ...

hiYes the Reported distance of the backup route should be less than the Feasible distance for the pr...

if it would it will at the time of change. Make sure it speed and duplex match.thanks

hiAre your sure you unloaded the correct IOS. Can you break into Rommon and boot the router from the...

hithe variance command and unequal load balance will work if your backup route Admin distance is les...

Just my 2 centsFor variance to work you must have a Feasible successor. Your backup routes may not b...

hi I used the formula metric - [(10^7/64)*256]= total delay *256Thus using this formula i get 405120...

thank ufor my benefit could u please post the equation with the variables. This delay must be added ...