About philasam79

philasam79 · 11-25-2021

Hi folks. I'm trying to upgrade my C9500 that is in VSS to IOS image Cat9k_iosxe.17.03.04.SPA.bin in install mode. when i issue the command "install add file flash:Cat9k_iosxe.17.03.04.SPA.bin activate ISSU commit. It fails to perform the upgrade. I ...

philasam79 · 01-22-2021

Hi all, I have just brought up my Apic1 simulator. I did not change any of the default settings. The only parameter i changed was the IPv4 address for the mgmt to match my network. When i logged in, one leaf was already discovered. I registered the f...

philasam79 · 01-28-2020

Is Cisco ever gonna reopen more seats for candidates who have been trying to hard to pass the exam before the scheduled CCIE retirement date? Please, help people like me who are very close to getting the number opens up a slot around all the centers ...

philasam79 · 12-04-2019

Hi all,I have three controllers in Mobility mode. the Mobility Anchor is spontaneously flapping and I have tried to remove the mobility features and readd the peers. It was fine for a short time. Then after a few hours, it started flapping again. So,...

philasam79 · 08-01-2013

Hi everyone,I would like to know what Cisco Network Engineer L3 level means and the expected tasks to be delivered by this L3 Networking Engineer.ThanksSamuel

philasam79 · 11-26-2021

Thank you Leo for your consistent followup. It didn't appear to me that my images in the flash may be corrupt. After i formatted the flash. I i rebooted the chassis from ROMMON with the .BIN extension. After a complete boot, i copied the image to fla...

philasam79 · 11-26-2021

Ran the command after the reboot. This is the ERROR. The same error is what i will also get after i have ran "install abort issu.!c9500_core#install add file flash:cat9k_iosxe.17.03.04.SPA.bin activate commitinstall_add_activate_commit: START Sat Nov...

philasam79 · 11-26-2021

I set the boot variable to "boot flash:packages.conf".Remember that i had said that if packages.confi is not present in the flash:, the install will not know where to locate the file? Hence, during a reboot, there will be an ERROR.This is the boot ER...

philasam79 · 11-26-2021

I have ran this command "install abort issue" more than 5 times today and tried to attempt the install over and over again. Everytime, i abort the install, i get the same error right when i tried to install the image.!c9500_core#install abort issuins...

philasam79 · 11-26-2021

c9500_core#install add file flash:cat9k_iosxe.17.03.03.SPA.bin activate commitinstall_add_activate_commit: START Sat Nov 27 01:54:01 UTC 2021System configuration has been modified.Press Yes(y) to save the configuration and proceed.Press No(n) for pro...

Member Since	‎03-01-2013 10:35 AM
Date Last Visited	‎12-01-2021 12:06 AM
Posts	24

User Statistics

User Activity

C9500 Install Mode issue

APIC1 Registered nodes stays inactive mode

CCIE lab slot availability

How can i capture traffic on cisco controller to determine caus

Cisco Network Engineer L3 level

Re: C9500 Install Mode issue

Re: C9500 Install Mode issue

Re: C9500 Install Mode issue

Re: C9500 Install Mode issue

Re: C9500 Install Mode issue