About gilbert.aispuro1

gilbert.aispuro1 · 07-15-2021

Hello All,Not sure if I'm in the right community but I have Snort running on all edge devices, and I'm seeing that encrypted emails and their attachments are not retrievable by the recipient. I know the domain of the end party trying to send the encr...

gilbert.aispuro1 · 06-30-2021

Why is Network Discovery Only default on FMC and not Block All Traffic?

gilbert.aispuro1 · 05-13-2021

Hello Team,I have two vEdge virtual routers in Azure and I need a server that's behind them to be publicly available. Has anyone config'd this yet? I think I have a good understanding of what I need to do but figured to throw this out there.

gilbert.aispuro1 · 03-06-2021

My setup is two cEdges running VRRP. In my scenario,cEdge01 is Master and has two ISPs connected to it. cEdge02 is Standby and has one ISP connected to it. Each TLOC-X has it's one cable, so three cables connecting between the cEdges. All vManaged. O...

gilbert.aispuro1 · 02-05-2021

I'm looking to export my C9120AXI-B AP data such as, interface(bandwidth, status) , CPU, Memory, to a CSV so I can ultimately pull that data from PowerBi. I would like this to be automated everyday if possible. My APs are managed by 9800WLC.Has anyon...

gilbert.aispuro1 · 07-15-2021

So I ended up working with TAC on this and to get it working, I had to enter a default route pointing to the IP of the TLOC interface on cEdge02. Although this does make sense and I did think about adding it but it was not a command listed or mention...

gilbert.aispuro1 · 05-26-2021

My vEdge pair are in the same VNET as the server.

gilbert.aispuro1 · 05-26-2021

Hello,So you're saying there is no need for configuration on the vEdges?

gilbert.aispuro1 · 03-06-2021

The firewall and router is the cEdges. There is no separate devices. There is no issue with ISP3. It has full connectivity if I make cEdge02 the Master.

gilbert.aispuro1 · 03-06-2021

Are you able to delete the Available version? I'm sure it's 20.1. If not, then I ran into this issue as well and you might have to remove via CLI.Try doing: request platform software sdwan software set-default 20.3.2.1then request platform software s...

Member Since	‎04-20-2017 09:40 AM
Date Last Visited	‎12-21-2021 05:57 PM
Posts	131
Total Helpful Votes Received	96

User Statistics

User Activity

Snort blocking encrypted email attachment

Why is Network Discovery Only default on FMC?

vEdge Static NAT for Websever

TLOC-Extension Not Working?

Export Wireless Data to CSV File

Re: TLOC-Extension Not Working?

Re: vEdge Static NAT for Websever

Re: vEdge Static NAT for Websever

Re: TLOC-Extension Not Working?

Re: Failed to set default version to 20.3.2.1