About andrew_ho

andrew_ho · 10-29-2014

Hi,I know the show caller command can see how long a PPPoATM session has be up for. Active Idle Line User Service Time Time Vi4 vMELBbr...

andrew_ho · 08-15-2012

Hi, I ran into a situation where I have to configure a router to peer with two un-related routers (belong to two different organizations) using the same private AS.Router A (AS 64514) --- Router B (AS 65007) --- Router C (AS 64514)I have control of ...

andrew_ho · 11-13-2011

Hi,My router has an existing OSPF route of:O E2 10.183.161.64/27 [110/1000] via 168.217.1.251, 00:03:12, Vlan101When it learns the same route from BGP, I would expect OSPF route to be replaced by the BGP route. However, this doesn't happen. The ro...

andrew_ho · 08-22-2011

Hi Guys,Anyone knows a way to termporarily disable a particular IPSec tunnel on a Cisco router provided:- No change of configuration- Not affecting other running IPSec tunnels- GRE is not being used, so there is no tunnel interface to shut downOr any...

andrew_ho · 03-07-2010

Hi,I have a CUCM 6 and a 2621XM with NM-2V and VIC-2FXO. The router is configured as a H.323 gateway as shown below. Outgoing calls from 8001 are working fine. However, incoming calls (which should all be forwarded to 8001) are not working. It keeps ...

andrew_ho · 10-30-2014

Hi Afroz, Can't find that OID. SNMPv2-SMI::enterprises.9.10.19.1.3.1.1.3 = No Such Object available on this agent at this OIDIt is a Cisco 887VAG running 15.3(1)T. Regards,Andrew

andrew_ho · 08-15-2012

Hi Peter,The actual situation is more complicated than this, where router A & C are also indirectly connected via some other AS in between forming a loop, or redundancy if you wish. I did try the allowas-in approach, it worked. However, it won't be ...

andrew_ho · 08-15-2012

Hi All,In fact, I am looking for the "as-override" feature but in a non-mpls setup. I have tried on IOS 12.4 and 15.0 but cannot find this command? BTW, I have tried on a Cisco 1941. Is this feature specific to particular model or feature set? Any id...

andrew_ho · 08-15-2012

Hi,Forgot to mention that routes need to be exchanged between router A and C.Andrew

andrew_ho · 11-15-2011

Hi Milan,Yes, OSFP is also redistributed to BGP. However, this route should have been filtered out by a route-map. The idea is to have the route learnt from a different AS. But there is also a floating static on the local AS (ISDN headend router) wh...

Member Since	‎03-08-2006 04:44 AM
Date Last Visited	‎04-10-2018 07:19 PM
Posts	31

User Statistics

User Activity

SNMP OID for PPPoATM active time

How to peer with two un-related routers which are using the same BGP AS

BGP and OSPF route issue

How to disable a particular IPSec tunnel on Cisco router

H.323 gateway FXO incoming calls not working.

Hi Afroz, Can't find that OID

Re: How to peer with two un-related routers which are using the

Re: How to peer with two un-related routers which are using the

How to peer with two un-related routers which are using the same

BGP and OSPF route issue