About jasonhilt69

jasonhilt69 · 12-30-2015

I have several 7942G phones where the on/off hookswitch isn't working. You pick up the handset and nothing happens. If you select New Call or Answer the handset works just fine. On 7941/61 phones I was able to take the phone apart and bend out the...

jasonhilt69 · 07-28-2015

Have an issue with our FXS ports that are used for fax machines. If a call is active on the fax line and another call comes in to the same number, it locks up the phone system - phones can't do anything, buttons dont work for a minute or so and no c...

jasonhilt69 · 07-21-2015

CUCM 10.5.2.11900-3, recently upgraded from 6.xxCalling to an outside number from a remote building, caller ID shows the wrong building on some phone carriers, but is correct on AT&T which provides our PRI lines.Example: Call to my AT&T cell, caller...

jasonhilt69 · 04-06-2015

First off, our servers are old, EoL, EoS. New servers are planned but wont be here for quite awhile.Our voicemail server is dying. It will just shutdown at random times for no reason that we can find. Normally wouldn't be a problem as we can go wi...

jasonhilt69 · 12-30-2015

None of those helped as the 7942G phone doesn't use that kind of spring or hookswitch contact. It uses an electric eye like this one: http://www.refurbsupplies.com/storefrontCommerce/itemDetail.do?itm_id=2217 It acts like the eye just quit working f...

jasonhilt69 · 07-31-2015

We have a contractor scheduled to look into the fax issue along with our caller ID issue next week. I think we'll survive for now.Thank you for your help. I learned quite a bit.

jasonhilt69 · 07-31-2015

I was able to reconfigure the fax lines on the one gateway that uses MGCP. I now get a busy signal on the second call and no system lockup.Now the problem is, the other gateways are on h.323 and a second call to those pots lines locks the system. T...

jasonhilt69 · 07-29-2015

Debug isdn log is attached.My call from 4592222 to 7243 starts at line 129 in Notepad++. It connects and I hear the fax tones. I then call from my desk phone, 8626646 to 7243. Starts at line 633. This call I get dead air.Same is true if I call from...

jasonhilt69 · 07-29-2015

On fax dial-peers, fax rate disable command is not available for pots. Only see it on a dial-peer voice voip config.removed port on mgcp configOnly overlapping route patterns I see for 7243 are on the gateway itself. Dial-peer voice 111 voip and 11...

Member Since	‎09-10-2009 03:40 AM
Date Last Visited	‎05-14-2021 12:35 AM
Posts	24
Total Helpful Votes Received	5

User Statistics

User Activity

7942G Hookswitch not working

Calls to FXS port - Fax line locks Callmanager

Outside caller ID wrong

Can't make calls when voicemail is down

None of those helped as the

We have a contractor

I was able to reconfigure the

Debug isdn log is attached.My

On fax dial-peers, fax rate