You are absolutly right in that you are not the only one with this problem.Check this post and the l...

Last thing first:access-list 101 permit icmp 172.16.0.0 0.0.0.255 any tracerouteI hope it works, but...

Try and replace this:access-list 101 permit ip 192.168.0.0 0.0.255.255 any access-list 101 permit tc...

I think the reason why the log shows you the private address insteed of your WAN address, is somethi...

Exactly, you want the one with a Ethernet WAN if you want to use the same router for both dsl and ca...

I think all it needs is this "bridge 1 protocol ieee".

Sundar is absoloutly right it is a NAT issue.And unfortunatly you won't get around it without having...

I'm guessing Paul needs to add route-maps to his NAT statements, kind of like this:ip nat inside sou...

Well at least now the Layer 1 status is ACTIVE, thanks.However I'm still not able to make outgoing c...

I just upgraded my C2650XM to IOS 12.4(9)T1 because I had instability problems with the old 12.4(4)X...

Well according to this http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_command_refer...

interface Ethernet1/1ip address dhcp client-id FastEthernet0/0 hostname Whateveror just this.interfa...

Is the router a 2600XM or just a 2600? And what about the IOS is that the 2600XM or the 2600?As the ...

Well then either you have come across a bug, or more likely "import all" isn't supported when runnin...

Could you post the output of this command "sh ip dhcp import"?