About fasteddye

fasteddye · 07-27-2010

I have a 3750G-PoE-48 stack with 4 units. Member 3 of the stack has around 15 ports with Receive Err...

fasteddye · 06-17-2010

We get some HighQueueDropRate Alerts from Cisco works on our 2600 Routers with T1 links.These look t...

fasteddye · 06-10-2010

I noticed that on one of our 3750 switches we have both the mls qos trust cos and service-policy inp...

fasteddye · 06-07-2010

The 3750 it is uplinking to is just an edge switch at Layer 2. That 3750 then is a direct connect to...

fasteddye · 06-07-2010

I am connecting a 2960-24LT-L to a 3750 via a Gigabit Ethernet port. I have run the cisco-switch mac...

fasteddye · 05-26-2010

When I entered the auto qos voip cisco-phone command, it generated some lines that I am not sure abo...

fasteddye · 05-26-2010

I have pasted a few config examples.Here is a sample of our normal QoS config on all switches.mls qo...

fasteddye · 05-26-2010

Thanks for the reply Jon.All of our 3560 and 3750 switches are used as L2 switches. We use trunk por...

fasteddye · 05-26-2010

Can I use a config from one of our other 3560 or 3750 for a 2960? We have some older 2950s that are ...

fasteddye · 04-12-2010

After reading the readme on the MDS device package, it appears we have quite a few dependent package...

fasteddye · 04-09-2010

The MDS 9124 are failing on the system config collection. I have tried to look at available packages...

fasteddye · 04-05-2010

Thanks for confirming my findings. We will have to wait for CiscoWorks support on those devices.What...

fasteddye · 04-01-2010

I am new to CiscoWorks, so after doing some poking around I found that I may need to download a pack...

fasteddye · 03-31-2010

We are getting failures on our archive management job for all of our Voice Gateway (VG) devices. Do ...

fasteddye · 03-03-2010

I am looking to get some ideas/recommendations on a network monitoring software solution for our net...

3750 Receive CRC Errors