rwagner

I generally avoid native vlans being included in any interconnecting traffic. The reason is as you d...

You asked a very broad question without any real details about the connections.So I will talk in som...

If you are dropping connections then I would suggest you start doing packet sniffing. If you were on...

I have never seen a deployment where you give 3 different default routes. Someone may have gotten it...

You can run pppoe and pppoa on the same device. Since you do not have pppoa running then we can safe...

CISCO-VPDN-MGMT-MIB::cvpdnSessionTotal?Please confirm that you have no pppoa connections.{edit} whic...

Check out the following troubleshooting guide:http://www.cisco.com/en/US/tech/tk365/technologies_tec...

I would recommend reading the following white paper and then updating your post with a more specific...

The only time I have seen this type of issue with the scenario you are describing is when steps were...

You say you have used all of your private class C address' but your network topology suggests that y...

sounds like you need to add a static route.ip route 10.10.20.0 255.255.255.240 FastEthernet0/1even t...

I had a very simular issue during one of my earlier ipv6 depolyment tests. I would recommend running...

The most likely cause of this would be packets/frames from protocols that the device doesn't underst...

Assuming that your Domain Controllers are not normally accessible then we can assume that your VPN t...

Have you configured "MAC Changed Notification"?, or if you are using 4.1(3)+ "MAC Move notification?...