Well, I guess we are telling the same thing, however lets try to visualize a bit to clear off the inbound / outbound interface part. R11- 1.1.1.1R13 - 3.3.3.3 With default Costs :- R11#sh ip rou 3.3.3.3Routing entry for 3.3.3.3/32Known via "ospf 1",...
Yes, if you are looking at the direction of the route update (incoming interfaces) or as RFC 2328 states, "a cost is associated with the output side of each router interface" e.g.The route update from R3 would add the advertised cost from R3 + R2 (in...
Prabhakaran,If you have configured static routes pointing towards Airtel router, no matter what the switch will always route the traffic to that even if there is failure at WAN.Consider deploying two static routes (floating as we call) from your swit...
STP Loopgaurd is used to prevent STP loops occuring due to unidirectional links.This feature is similar to UDLD, but it uses STP BPDU keepalives if there is a unidirectional link.Ideally loopguard should be enabled on all the interswitch links.
Duncan,Is there an experience of slowness from a hosts perspective ?Also if you could generate a granular report with respective to the X axis it would help.Off business hours, you may have to test the throughput preferrably using TCP and check the s...