trombidz1

Sorry , I would like to be more precise :We have actually on the supervisor, an msfc card attached t...

My problem is how to choose the correct Supervisor ? also are msfc always on board ?

We would like to change this 6500 to use the part as spare for my Primary site.This has been budgete...

Hi I need to change my Catalyst 6500 at my DR site. Here are the module I have inside : Mod Slot Por...

Hi I need to change my Catalyst 6500 at my DR site. Here are the module I have inside :Mod Slot Port...

Hi ,this morning , I tried to access one of my firewall via https and during to config load , it cra...

Hi , I would like to configure a router to route two different traffic ( one for DMZ 192.168.60.0 an...

$oftware, CBS30X0 Software (CBS30X0-LANBASE-M), Version 12.2(25)SEF1, RELEASE SOFTWARE (fc3)

version 12.2 no service pad service timestamps debug uptime service timestamps log uptime no service...

version 12.2no service padservice timestamps debug uptimeservice timestamps log uptimeno service pas...

Hi,Any ideas ?cheersDavid

I tried to put all the port into a 1gig switch and it is still the same issue1 port is trunking fine...

again,thanks for your prompt responseI read an article that you can not do a trunk between a 1000 po...