I've got an issue whereby spoke routers in a DMVPN configuration will not send an RPT PIM join message towards the RP (which is through the DMVPN hub) to join the shared tree. The RP actually lies behind the DMVPN hub on a tandem router.There is no m...
How's it going?So I'm trying to force myself to use an access-list to redistribute an IPv6 static route into OSPFv3... I can do it no problem using a prefix-list but cannot figure out the logic for the extended IPv6 access-list, any direction or link...
Hey folks,I'm trying to decide which implementation is more applicable for my enviornment. Here is the background:I work in an organization which uses a fair amount of event based video. Video would be considered a critical application. With the adve...
Hello forum,I'm trying to determine the security implications of utilizing 802.1x authentication/authorization with the "Domain Computers" option selected within ACS. The problem I am having with this scenerio is this:1) Client machines are authentic...
Hello,I've currently got a single firewall running as Secondary/Active. The Primary firewall is offline. Here is my question:If I change the Secondary/Active firewall to Primary/Active will it do any of the following:1) Create a fail over event?2) Wi...
Thanks Peter,So to get the questions out of the way:1) Yes2) Yes3) YesThe join-group is applied to the LAN side interface of the spoke to force the router to join the group and emulate a connected receiver. The multicast source itself would be throu...
The closest I can get this to working is to use:"ipv6 access-list IPv6Statics2OSPF permit 2001:1111:2222:FF00::/56 any"But I'd prefer to make this permit only routes with a /64 prefix-length... using the above line, the router will advertise anything...
mguzman4158,I just set this up on a few routers and the reason why you see the /24 is because IOS uses a longest-prefix match (/24 is longer than /22). If you type the following command, "show ip route eigrp" you can see all three routes as follows:R...
Have you seen this switch:http://www.cisco.com/en/US/prod/collateral/switches/ps6568/ps10956/data_sheet_c78-601946.html* Cisco ME 3600X Series Ethernet Access SwitchesThanks,Jeremy
utawakeyou,I'm sure Cisco has a document for integration with HP, however I am able to find the HP one's quickly.www.g33k.de/blog/wp-content/hp-cisco%20trunking.pdfhttp://cdn.procurve.com/training/Manuals/ProCurve-and-Cisco-STP-Interoperability.pdfTh...
