About zanub

zanub · 07-24-2007

hi,yes u a right the ca certificate is optional in the client. i guess i mentioned server certificat...

zanub · 07-23-2007

hi, thanks for the reply..i'm using ms cert authority..i'm downloading the server cert into client m...

zanub · 07-23-2007

hi all, i'm tryin to get the certificate setup for the peap authentication for wireless clients.i in...

zanub · 04-23-2006

hi all,the problem has been solved by the link provider. we connected 2 laptops and both the ends an...

zanub · 04-21-2006

hi,i have a fast ethernet 100mbps link with ip address configured on either sides on a 7609 router w...

zanub · 04-21-2006

Hi,I have a PA-MC-E3 card between 2 7509 routers. It does not support single channel e3. so i have b...

zanub · 04-19-2006

Hi,u should have some traffic flowing for the link to come up even if it is backup interface. try ke...

zanub · 04-05-2006

Hi,These are the only commands available under controller e3CR7609(config-controller)#?Controller co...

zanub · 04-04-2006

Hi,I tried configuring E3 by dividing it into 16 channels and then multilinking. is there any way to...

zanub · 01-31-2006

Hi, Thanks for the reply. I found another way. it is to use dialer watch-group command and then defi...

zanub · 01-31-2006

Hi, How do i configure an PRI interface, so that it acts as a backup interface(will dial to differen...

zanub · 01-23-2006

Hi, Thanks for the inputs on ISDN. Hope you don'e mind helping on another topic too.I have to get E3...

zanub · 01-03-2006

Hi,I've permitted all ip traffic.access-list 101 permit ip any any!dialer-list 1 protocol ip list 10...

zanub · 01-03-2006

Hi,Thanks for the reply. I have given a default route in the remote router, what other traffic shoul...

zanub · 01-02-2006

Hi,I have finally got both channels up. I want to know if there is any problem in ip ospf demand cir...

Re: acs server certificate