About zanub

zanub · 06-30-2011

Hello, I'm not able to find any clear documentation on how to configure Easy VPN Server for ASA5510 using ASDM to connect to a remote router. If i use the IPSec VPN Wizard and go to Remote access configuration, am not sure if it's the same if th...

zanub · 06-24-2011

Hello, I'm trying to setup Cisco 887g-w router with 3G GSM SIM card. We got a data sim card from telco with a static IP address. Below is the some outputs. The cellular interface keeps flapping, but am not able to ping at all to any public ...

zanub · 01-15-2009

hello,I have a Cisco 3560 switch which we found that the speed was set to 115200.So we tried changing the speed to 9600 in config mode and after saving, when we reload it goes back to 115200..So now we go to bootloader mode and set the speed there. s...

zanub · 11-26-2008

hey all,Is there any good attendant console supported by call manager express..basically we wanted the attendant console to work even if our wan link to the callmanager in dc fails...thanks in advance...

zanub · 07-07-2008

hi all, Is there any monitoring tool which can be used to measure the email traffic bandwidth usage going through our WAN interface. thanks

zanub · 06-28-2011

The issue was wrong APN provider by telco. Now it's working fine. Thanks for your support.

zanub · 06-24-2011

Hello Paolo, As requested below info.Cisco IOS Software, C880 Software (C880DATA-UNIVERSALK9-M), Version 15.1(1)T2, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2010 by Cisco Systems, Inc.Compiled Sat...

zanub · 01-18-2009

hi grant,i tried giving the set boot command in boot loader mode but, it still tries to boot with the old one first...hi mark,i also tried setting the baud rate to 9600 using set baud rate 9600 in boot loader mode...it goes back to the 115200 after a...

zanub · 01-16-2009

Hi Mark,It did not solve the problem. Next reload and it's back to 115200. However i noticed that other configurations are saved without any issues..well i also get this error message whenver booting the switch.Loading "flash:c3560-ipbase-mz.122-25.S...

zanub · 07-10-2008

hello,how do i check using the IOS itself...mine is a 3560 switch and want to monitor SMTP traffic going out a particular VLAN.thanks

Member Since	‎03-16-2004 09:42 PM
Date Last Visited	‎09-10-2018 02:07 AM
Posts	50

User Statistics

User Activity

Easy VPN Server ASDM

Cisco 887 3G

Line con 0

Attendant console

email traffic b/w

Cisco 887 3G

Cisco 887 3G

Re: Line con 0

Re: Line con 0

Re: email traffic b/w