About mwood000111

mwood000111 · 07-20-2020

We've installed the WebEx Monitoring Service from the Control Hub. Looking to add agents to our RoomKits, which register to the cloud, but we are seeing the error, "this is not an on premise device." Anyone else seeing this error or have any expe...

mwood000111 · 06-10-2020

Trying to set up the Breakout Tool. Followed installation instructions (https://developer.cisco.com/docs/modeling-labs/#!installing-breakout-tool) without any issues. The part I am getting hung up on is the configuration. Following this here, https:...

mwood000111 · 02-05-2020

Brief summary of issue is that sometimes when starting a meeting, whether it is scheduled or impromptu, the initial connection to the other client (usually another RoomKit in another location) experiences latency, lag in audio/video. Initial troubles...

mwood000111 · 12-10-2019

Installed the Room 55 Dual last week and have noticed that although on the GUI its set to speed auto and same on the access layer port (C9300), interfaces are negotiating only using 100MB. Port and data sheet indicate it should be able to use full 1...

mwood000111 · 09-17-2019

Consistently see output drops on TenGig interface (actually a 1GB fiber handoff using the TenGig SFP for MPLS) on a C9300 (16.9.1). Auto QoS applied to interface and softmax-queue is at 1200 on switch as well. Output from sh run int x/x/x, sh int x...

mwood000111 · 07-27-2020

Thanks Andres. I opened a TAC case the other day and had them confirm that.

mwood000111 · 06-11-2020

Found answer. You have to add https:// to the URL box. I was just using either the IP address or FQDN without https://. Good to know.

mwood000111 · 06-11-2020

Connectivity is there. ICMP and tracert are successful to controller address. Since CML/VIRL 2.0 is new, there isnt too much documentation and troubleshooting info out there. Ill try starting from scratch with this tool or moving this from a Win10 ...

mwood000111 · 02-06-2020

Thanks for the link Mike! Ill investigate this solution to see if we can stand this up and demo/test our network. Appreciate it.

mwood000111 · 02-05-2020

Thanks for the reply Mike. You are correct, these are registered to the cloud. Yes, possibility of internet traffic getting dropped outside of our network, within ISPs network is totally legit. Just want to make sure everything within our network i...

Member Since	‎07-21-2016 11:44 AM
Date Last Visited	‎01-21-2022 12:05 AM
Posts	43
Total Helpful Votes Received	6

User Statistics

User Activity

WebEx Monitoring Services

CML 2.0-Breakout Tool Error

RoomKit Quality Issues

Cisco Webex Room 55 Dual Negotiating only 100MB

Output Drops on C9300

Re: WebEx Monitoring Services

Re: CMML 2.0-Breakout Tool Error

Re: CML 2.0-Breakout Tool Error

Re: RoomKit Quality Issues

Re: RoomKit Quality Issues