Hi,There was no Internet connection this morning and I looked at the router - the CD light was blinking fast.Router did not respond to SSH connection and I plugged in the console cable.sh run had factory default configuration. So I've restored the la...

Using CCP I am trying to create a NAT entry for a range of ports. CCP window for a new NAT has only one entry for the port #.Is it possible to set uf port ranges in 877 router?

Hi,This router was initially configured thru SDM software and later modified by CCP. They created the following ACLs:access-list 1 remark INSIDE_IF=Vlan1access-list 1 remark CCP_ACL Category=2access-list 1 permit anyaccess-list 2 remark Auto generate...

I am trying to set up Cacti to plot the ADSL values for investigation of systematic dropped carrier.What am I doing wrong?In IOS:#sh run | inc snmpaccess-list 11 permit 10.10.10.3access-list 100 permit udp 10.10.10.0 0.0.0.255 host 10.10.10.1 eq snmp...