spremkumar

spremkumar · 01-13-2011

HiAs mentioned by leo its a very broad topic which deals the involvement of multiple protocols both ...

spremkumar · 01-13-2011

HiBased on your post i undertsand you are getting a ethernet drop from your ISP which you are curren...

spremkumar · 01-12-2011

HiAre you seeing continous increments within the output drop counter? can you check clearint the cou...

spremkumar · 01-12-2011

HiCan you post your configuration here?regds

spremkumar · 01-12-2011

HiSince you are going to connect the link onto a gigethernet interface you dont need those commands ...

spremkumar · 01-12-2011

HiIt looks pretty simple you just need to configure the ip address on the interface, preferably you ...

spremkumar · 01-11-2011

hi muneeryou need to have one sup and can go for 2 sups if you are particular about supervisor redun...

spremkumar · 01-11-2011

hisince the status is primary - failed i would suggest to do a hw reset, hw-mod mod x reset ( where ...

spremkumar · 01-11-2011

Hi JohnThough your utilizations hasnt peaked up there are good chances of them spiking out once you ...

spremkumar · 01-11-2011

HiIf i am not wrong you are looking like something below.crypto isakmp policy 1hash md5authenticatio...

spremkumar · 01-11-2011

Hi SteffenI would go with bandwidth command under class class-default as well. I hope you are reserv...

spremkumar · 01-11-2011

hi Victorsince you are emphasising this as a working config have you ever checked the status of the ...

spremkumar · 01-11-2011

Hi JohnI would suggest to check the utilization on your router first also the pattern in which the u...

spremkumar · 01-11-2011

hican you tweak you NAT ACL to deny only 10.10.144.0 0.0.0.255 to remote subnet similarly 192.168.24...

spremkumar · 01-11-2011

hi tarancan you paste the configs here?regds

Date Registered	‎01-22-2003 09:42 PM
Date Last Visited	‎08-18-2017 03:55 AM
Total Messages Posted	5,192
Total Helpful Votes Received	1987

Re: LAN Redundancy