About rsmith

rsmith · 07-12-2019

I was running a TraceRoute to a remote server that goes through our new ASA5516x Firewalls, via a Private link to our Partner site, I know it is at least 5 hops in to reach this server, as we just migrated from our older 55xx EOL Firewalls, and could...

rsmith · 10-05-2017

I have seen configuration examples for a single router VPN redundancy to a pair of routers, but what if you have a pair of routers at each end? I am hoping to achieve full VPN failover redundancy for any device failure. Is it as simple as adding the ...

rsmith · 09-26-2017

New 4351/4331 Routers, configuring simple Multicast as currently running on other model routers.(pim sparse-dense-mode)Stream to destination works when the Router source Gigabit port is placed directly on the MCast Source network, but fails when plac...

rsmith · 12-10-2012

We have a situation where we host an Image Server locally, but the Application Server that serves up the Images is at a Remote Vendor site that we access through a 2811 Router using NAT.The Image Server has a NAT address on the Vendor DMZ network, an...

rsmith · 01-06-2012

I am planning an implementation of VSS on our two 6509 switches, and would like some feedback on things to look out for, and any issues encountered by others that have done this already.We have the 10Gig port installed on the Management blades, but n...

rsmith · 07-12-2019

Thank you, but as we "Trust" the partner network, we already allow all ICMP from their networks back through our firewall.The issue isn't return traffic, but the ASA responding FOR the Remote servers. (It shows valid Response and the "END Server" DNS...

rsmith · 01-04-2018

I have the 4 Routers set up with HSRP, and VPN on the Virtual IP, but it does NOT transfer the VPN state when the routers fail over. Below the question is the (cleaned) configuration I currently have: 1: Per this document below, one caveat states "...

rsmith · 10-06-2017

Thank you!.. I did not know about the profile and local address piece. Below is my conceptual configurations, I know there is extraneous (probably conflicting) configuration information, and very likely some missing pieces still. I am hoping for some...

rsmith · 10-05-2017

Found main issue was with the HP Comware 5900, software revision installed has multicast bugs. Added work-around, fixed some Firewall configuration issues, and all multicast is now working through the Routers.

rsmith · 09-27-2017

Further update:Stage 1 still the same (35-40 seconds to populate the "announce")Stage 3: If selected repeatedly (after acknowledge of WMP error message, keeping the WMP window open), eventually it will "CATCH" the stream and start playing...It appear...

Member Since	‎04-15-2004 11:36 AM
Date Last Visited	‎09-01-2020 11:06 AM
Posts	172
Total Helpful Votes Received	50

User Statistics

User Activity

ASA5516 responds for a Trace Route to remote server

Four 43xx routers VPN FULL redundancy?

Multicast issues on new 4351 Router

Router NAT Hairpin or Redirect?

6509 VSS Implementation/migration 'Gotchas'

Re: ASA5516 responds for a Trace Route to remote server

Re: Four 43xx routers VPN FULL redundancy?

Re: Four 43xx routers VPN FULL redundancy?

Re: Multicast issues on new 4351 Router

Re: Multicast issues on new 4351 Router