About adeebtaqui

adeebtaqui · 03-12-2024

Greetings, Kindly advise how many P60 camera can codec pro support simutaneously. Is it 3 or 4 using hdmi And do we need an additional switcher to control these or just we need to connect each p60 via hdmi and lan port to manage and control.

adeebtaqui · 12-26-2023

Kindly advise if SM-X-8FXS/12FXO in C8300-2N2S-6T has 12 FXO ports inbuilt or we need to order 3 NIM-4FXO with each service module. Hence to connect 32 PSTN, we would need two SM-X-8FXS/12FXO with 3*2=6 NIM-4FXO to provide 24 FXO ports and then add ...

adeebtaqui · 08-02-2023

Greetings, Kindly advise how to get new 7821 and 8851 ip phones registered on ISR 4451 being deployed as CME using below flex subscription. Smart license have been activated but still phones not being registered. IP phone license 12 month subscripti...

adeebtaqui · 07-20-2023

what is the purpose of switch cmd "ip tacacs source-interface vlan X(mgmt)"? Is it a must to configure or more secure ?

adeebtaqui · 07-19-2023

Wanted to know if we can install 2nd power supply in Catalyst Switches while switch is on or should we power of switch

adeebtaqui · 12-26-2023

The end user has asked for SIP line but it seems it will take very long time.

adeebtaqui · 08-13-2023

How did you resolve this registration issue

adeebtaqui · 08-07-2023

this config I already have but still my phones not getting registered

adeebtaqui · 08-07-2023

how did u bind to interface

adeebtaqui · 08-07-2023

Below is the output. I see 30 registration requests but under pool its 0. Is this because of new flex licensing which may need to be activated in addition to active license of cme License Usage:License Entitlement Tag Count Status--------------------...

Member Since	‎10-13-2015 05:33 AM
Date Last Visited	‎03-20-2024 01:25 AM
Posts	438
Total Helpful Votes Received	75

User Statistics

User Activity

Webex Codec Pro max P60camera management and control

8300 - service module for 32 pstn lines

Cisco ISR 4451 as CME and activation of new Flex CME subscription

what is the purpose of switch cmd ip tacacs source-interface vlan X

Cisco 9300 power supply installation while powered on

Re: 8300 - service module for 32 pstn lines

Re: 7821 SIP Phone will not Register with CME - Config Attached

Re: Cisco ISR 4451 as CME and activation of new Flex CME subscription

Re: 7811 ip phone registration - reg send failure register

Re: Cisco ISR 4451 as CME and activation of new Flex CME subscription