Hi expert, I would like ask what is the maximum ACL entries which CGS can support? 1. How many ACL entries can support in CGS 2520?2. Will TCAM be utilized if ACL entries configured in the local switch WITHOUT applied to any Vlan interface/physical...
Hi Experts, I am designing a Ring topology to connect all all DRs and back to CR sites. Do I need to consider what is the maximum DRs which I am able to connect in the Ring and I am thinking does the latency will be affected if more sites will join i...
Dear Expert, Sorry that I can't revise the previous diagram to make it clear and I have create a separate post to describe the situation. I know that the ospf area (backbone area 0) must not broken inside ospf domain. For other ospf area (e.g. area 1...
Dear Expert,
As I know, there is RRM to control the TPC power automatically to all AP controlled by WLC. Is there is any reason to create RF profile to set limit the power range in TPC setting under High Density environment?
Thank you!
Hi all,
I have just checked that Controller 5520 to check the AP Performance, I found that one AP is suffering from high channel utilization and high interference. Can any one teach me is it a normal case?
Number of user connected: 13
Channel Ut...
Hi Pmckezie, If the link between A-DR2 and B-DR1 is broken (orange link), the Area 10 will be discontinuous to different protons. Will this impact to the disconnection/ospf down in this case?
Hi Rick,Maybe I attach the diagram so that you can easily understand.According to the diagramR27,R28,R5,R6 loopback address is in Area 0Sw27,Sw28 loopback address is Area 20Sw5,Sw6 loopback address is Area 10My question is normally R28 's routing tab...
Hi Gouseppe,Thanks for your explanation. But I still not understand. May I ask more question?Why R27 choose the best path from R6 about route 1.1.1.1 In R6 router there is no local preference set on the link (connect to AS123) only weight is set. Th...
I don't want to change the normal data routing on the routing table ( best route Vlan 110, Vlan 108 is backup path)But I want to use Vlan 108 for primary multicast route and Vlan 110 as secondary routeHow can I config it ...It seems I can't set two i...
it seems fail. any one know the issue ?interface Loopback0 ip address 1.1.1.1 255.255.255.255!interface FastEthernet0/0 ip address 192.168.1.1 255.255.255.0 duplex auto speed auto!router bgp 10 bgp log-neighbor-changes neighbor 2.2.2.2 remote-as 20 n...