About echelon360

echelon360 · 09-17-2009

Hi,I'm wondering if anyone has encountered a similar issue and if there is a way to resolve this.We are conducting tests around BGP link failure detection on the uBR10k/SIP-600/10GigE SPA where it is taking around 8-9 seconds to detect the fibres bei...

echelon360 · 06-08-2009

Hi,ISR 2811I have several ACLs running on this router. Is there a way i can gather stats to see how much of resources the router is assigning to these ACLs?thanks!

echelon360 · 06-01-2009

Hi,I need to setup a 3750 and a 3845 in the same vlan for a test. I'm thinking the only thing i need to do is to configure a subinterface on the 3845. Pls advice i'm missing something impt3750-------interface gi1/0/5switchport access vlan 203845-----...

echelon360 · 05-31-2009

Hi,Can someone with ixia experience pls advice how best to perform this test?Attached is the test setup.I'm trying to use ixia to generate packets to flood the ethernet module of the router. -should i have each of the 3750<>2811 ports be setup with i...

echelon360 · 04-02-2009

Hi all,I'm trying to setup a packet flow between Host A and B using netperf but i am unable to generate the packet. I think i'm missing something with the translate statements. Please advice if the statements i have are not correct.(pls reference dia...

echelon360 · 06-09-2009

thanks Giuseppe! Appreciate your responses.I had a look in detail on this and from what i understand, i think it requires the TurboACL feature to be enabled (access-list compiled) before it is active on the router.http://www.cisco.com/en/US/docs/ios/...

echelon360 · 06-03-2009

thanks Giuseppe!

echelon360 · 06-02-2009

Thanks Giuseppe!I have updated the test topology and included what i think will ensure tests for ethernet module stress test and ACL limitations. Pls let me know your thoughtsEthernet Moduleexample port 1ixia (6/4)------(192.168.4.0/24)define stream ...

echelon360 · 06-02-2009

thanks Giuseppe!How can i improve this setup on port 6/4. Have this port connect to another port of the 3750 as well?I will need to test out ACL limitations on the 2811 ethernet module and hence, i believe i will need to have each of the 9 port on an...

echelon360 · 04-19-2009

hello rajeev,Nortel uses MLT for etherchannel configs.have a look at page 329 of the attached doc.HTH

Member Since	‎05-23-2004 01:38 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	144
Total Helpful Votes Received	7

User Statistics

User Activity

ubr10k bgp convergence issue

memory process allocated to ACLs

Vlan on 3845 gi0/0

Ixia traffic test (Ethernet load)

X25, issue with translate statements

Re: memory process allocated to ACLs

Re: Ixia traffic test (Ethernet load)

Re: Ixia traffic test (Ethernet load)

Re: Ixia traffic test (Ethernet load)

Re: etherchannel configuration between cisco and nortel