About albert_coll

albert_coll · 03-08-2017

Hello, I should install an ACI fabric shortly, but my Spine switches order is delayed for some time. So in the meantime, may i use 2 x N9K-C93180YC-EX border leafs, plus other two leaf switches of the same model meshed with 40Gbps interfaces to bui...

albert_coll · 01-31-2017

Hi, I need to integrate two legacy Fabrics (Brownfields) at L2 to an ACI fabric tenant to migrate bare metal equipment into it. Both legacy fabrics are now running isolatedly, and present some degree of vlan overlapping since in some cases each ...

albert_coll · 11-12-2012

Hello,In a BGP autonomous system with several Route Reflector clusters into it, should all BGP clusters be fully Meshed?I read design docs of hierarchical RR architectures, where a backbone RR cluster is the hub of several “spoke” regional RR cluster...

albert_coll · 10-28-2012

HelloIs it possible to deploy a Fast Reroute (FRR) backup tunnel terminating in a node several next-hops downstream instead of just one?All the examples i found in the documentation about FRR Node Protection, -or NNHOP-, always illustrates one protec...

albert_coll · 09-21-2011

Hello FWSM experts,An FWSM V4.1 blade is operating with 15 ip interfaces, each one with its specific access list. The security managers say that maintaining a single ACL instead of 15 would represent a significant improvement. For that reason they su...

albert_coll · 01-31-2017

Cisco ACI Fundamentals V1.1, section "Per Port VLAN" says: "Starting with the v1.1 release, multiple EPGs with the same VLAN encapsulation can be deployed on a given leaf switch (or FEX), as long as the EPGS are associated with different bridge doma...

albert_coll · 01-31-2017

Many thanks for your valuable aswer. Just for my information, regardind your second example: Could i, for instance, terminate the incoming vlan100 of Brownfield #1 as is in a leaf; and remap the incoming vlan 100 of Brownfield #2 to another vlan-id ...

albert_coll · 01-24-2011

Thanks Poonguzhali. I'll try it along the next few weeks

albert_coll · 01-24-2011

Thank you for your answer.The ASA is an 5540 which includes 4 embedded GigabitEthernet only. With the AIP SSM inserted in the slot. The current configuration diverts all traffic to the SSM. Which is configured as inline, fail-open mode: access-list I...

albert_coll · 09-29-2010

Thank you for your answer.In such case, can i deploy the FWSM in routed mode between vlans with MSFC SVI interfaces assigned to different VRFs? For instance, can i assign the FWSM outside interface to a vlan in which there is also an MSFC SVI assigne...

Member Since	‎04-09-2003 04:19 AM
Date Last Visited	‎04-22-2020 12:29 AM
Posts	80
Total Helpful Votes Received	10

User Statistics

User Activity

Using Leaf switches N9K-C93180YC-EX back-to-back without spine in between

isolating overlap of vlans when entering into ACI

Advice on RR clusters deployment

FRR NNHOP node protection with multiple protected nodes?

FWSM acl rules question

Cisco ACI Fundamentals V1.1,

Many thanks for your valuable

Re: Help with underrun between an ASA5540 – ASA-SSM-20.

Re: Help with underrun between an ASA5540 – ASA-SSM-20.

Re: FWSM bridge-group between two VRF interfaces