About rajatsetia

rajatsetia · 03-28-2008

As they say " its possible to use same ip address for loopback interfaces in different VRFs"but even if ospf process running in different VRF they cannot use same router-idbut my question is "why this kind of behaviour?"is this ospf which is not allo...

rajatsetia · 03-13-2008

Scenario :R1--IBGP--R2--EBGP--R3 R3 with private AS If we use this command "remove-private-as" at R2 to remove private AS while it advertise R3 prefixes to its neighbors.I think if there is IBGP between R2 and R1 then R2 wonnt strip the private AS fr...

rajatsetia · 03-12-2008

Scenario :-R1--IBGP--R2--EBGP--R3R2 applies community AS:NN to inbound updates of R3 route-map test permit 10 set weight 0 set origin igp set community AS:NNthen while sending the updates to R1 and applies the following route maproute-map set-next-ho...

rajatsetia · 08-29-2007

In OSPF Hello process, if any of below mentioned item does not match, two routers do not form neighbor relationship:-- Must Pass Authentication- Must be in the same primary subnet, including subnet mask- Must be in same OSPF Area- Must be of same are...

rajatsetia · 07-19-2010

Hi Scott,try NAT overload with route-map rather than aclI think it should work, But WHY?? I vaguely remeber but not sure, will try to dig out something for you.e.g.ip access-list standard INTERNET_ACCESSpermit 10.2.1.0 0.0.0.127route-map test permit ...

rajatsetia · 06-07-2010

Hi,When operating at full-duplex, FCS, cyclic redundancy checks (CRC), alignment errors, and runt counters should be minimal. If the link is operating at full-duplex, the collision counter is not active. If the FCS, CRC, alignment, or runt counters a...

rajatsetia · 05-31-2010

Hi Taran,when you say Firewall does not support VIP, it is fine. Can you plese tell me how HA works in your firewall .what are IP addresses configured on your firewall and what will happen when primary fails ? and what is router's next hop IP Address...

rajatsetia · 05-31-2010

Hi,Agree with Calin that shaping is concept which is independent of vendor. Only configuration & specific features may change.But products like packeteer give many more features like compression and also they have much better monitoring & reporting f...

rajatsetia · 05-31-2010

Hi Manie,STP path cost used to be linear and calculation was very simple , 1000/Bandwidth in MbpsAs 1 Gbps & 10 Gbps came into picture, path costs have been revised and formula is not availavble (atleast I could not find it). cost are non-linear now....

Member Since	‎07-12-2007 03:10 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	124
Total Helpful Votes Received	69

User Statistics

User Activity

OSPF in VRF

BGP behaviour "remove-private-as"

BGP next hop ??

Reg OSPF behavior

Re: NAT Overload not functioning correctly on router

Re: Receiving FCS-Err on Cisco catalyst 6500

Re: regarding NAT between two ISP

Re: bandwidth allocation

Re: Etherchannel STP