Hi,Is there a command on CUE to find out if the 1 GB compactflash is in use? I don't find it on cco....

really good idea! I'll verify it when I have a chance. thanks a lot!

Hi, Paolo, can you elaborate a little bit? I don't think I get you. the customer is using T1 Pri for...

Hi, Nick,the customer uses 10 digits local dialing. there are 2 area codes: 604, 778. the challenge ...

On CME, I can prefix 9 on all incoming calls, however, it's difficult to distinguish local calls and...

command "sh telephony" shows explicitly that this mode is in use. but the actually behavior is blind...

if you input the extension mannually, the call goes thru. Cisco TAC determines this is caused by a b...

the softkey TrnsfVM on IP Phone works if followed by inputting an extension, but if I push the speed...

no, in different vlan. Even if they are in same vlan, since they are connected to different switches...

Hi,I've got 2 servers, connected to 2 Cat 6509 individually. I want to monitor both ports with 1 por...

Hi,If a T1 Pri is assigned only 10 channels by SP, and I bundle full channels (24) on Cisco g/w, wil...

thanks, MK.I do have 91 pattern for long distance calls. the problem is that some users forget to pu...

The setup is like this:[PSTN]--T1 PRI--[CUCM MGCP G/W]--T1 PRI--[Mitel PBX]--[analog phones]The issu...