About mopaul

mopaul · 10-04-2012

This video talks about how to configure and pair up two different controller for high availability. Video Series - New Features introduced in Wireless LAN Controller 7.3 Release You can also check High Availability Architecture in Wireless LAN Contro...

mopaul · 10-04-2012

mopaul · 10-04-2012

This video talks about the HA configuration on Cisco Wireless LAN 5500 controller using GUI. Video Series - New Features introduced in Wireless LAN Controller 7.3 Release You can also check High Availability Architecture in Wireless LAN Controller – ...

mopaul · 05-27-2016

Referring to below two documents, my bet goes to –N I see your post is 5yrs old. Did you make it work with "-N" ? >>> Refer this guide, page 31, Lists the countries that belong to each regulatory domain. http://www.net130.com/attestation/ccip/jc/Cis...

mopaul · 04-28-2016

Please refer my previous response :- "Also note, It is not possible to access the standby-hot controller through the controller GUI, Cisco Prime Infrastructure, or Telnet. You can access the standby-hot controller only on its console." Glad i could...

mopaul · 04-27-2016

1. Yes, SP can be in different VLAN than management and it should be configured that ways irrespective of HA or standalone 2. ICMP packets are generated from the Redundancy Management Interface to check the default gateway reachability of controllers...

mopaul · 04-26-2016

Yeah, If the controllers cannot reach each other through the redundant port and the RMI, the primary controller becomes active and the standby-hot controller goes into the maintenance mode. The WLC should be rebooted in order to bring it out of Maint...

mopaul · 04-26-2016

1. Try AIR-CT5500-K9-8-0-121-0.aes Release Notes 8.0.121.0 http://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn80mr2.html Release notes 8.0 http://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/wlcrn80.html#pgfI...

Member Since	‎11-14-2009 06:28 PM
Date Last Visited	‎09-21-2018 05:37 AM
Posts	92
Total Helpful Votes Received	120

User Statistics

User Activity

How to configure and pair-up two different controllers in High Availability mode using CLI

AP-SSO configuration using initial CLI configuration wizard

AP-SSO configuration using GUI

Referring to below two

Please refer my previous

1. Yes, SP can be in

Yeah, If the controllers

1. Try AIR-CT5500-K9-8-0-121