About shaps

shaps · 11-20-2015

can anyone advise on what cut off on AS-PATH length would be when accepting routes from peers, looking through some of the received routes the AS+PATH is pretty high and I would like to limit this down, is this strictly necessary ? If so what would ...

shaps · 10-29-2019

You can also check out the "show vpc consistency-parameters vpc <vpc-num>" which it mentions above.

shaps · 10-22-2019

What do the return routes look like from the headquarters to the branch, could they be using the VPN ?

shaps · 10-22-2019

Hard to tell without seeing the config, you mention the cisco switch does not have the IP address that the industrial switches are using as there GWIf it is not there you will need to add it under and SVI and trunk the relevant vlans to the industria...

shaps · 10-16-2019

You can use allow as in or as overide, on the CE or PE respectively.If I understand your query about the loop within the site with the two CEs then this shouldnt be an issue as ibgp vs ebgp with regards to routing should overcome this;You want both C...

shaps · 10-16-2019

the version is point 1 is so old I would assume it is eol and eos by now, either way you should have moved onto something newer by now.version in point 2, see belowhttps://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-x-series-swit...

Member Since	‎07-07-2015 02:39 PM
Date Last Visited	‎02-26-2021 04:15 AM
Posts	168
Total Helpful Votes Received	100

User Statistics

User Activity

Max AS Path to accept from peers

Re: Cisco VPC 9000 and Cisco 3850

Re: Route-Map Issue

Re: Cisco L3 switch to industrial switch

Re: BGP | avoid loops with redundant gateway

Re: Cisco IOS firmware support validity