josedunet

josedunet · 09-29-2010

hi ,Please Be that it means that we can register the number of telephone IP and softphone we want?Th...

josedunet · 08-18-2010

Please letian, Could i configure the L2VPN without MPLS. Because Quite my searches speak only about ...

josedunet · 08-17-2010

Hello all,I want to know if i can configure the Ethernet over IP on cisco router. This configuration...

josedunet · 03-03-2010

Thanks ganeshh.iyerIndeed, I would like to make the dual homing with 2 ISP1 and my local area networ...

josedunet · 01-29-2010

thanks Ganesh.H,If I understand you offered me the following config:interface fastethernet 0/1descri...

josedunet · 01-29-2010

hello,I have a 2811 router with 2 FastEthernet interfaces connected to two ISPs.FA0 / 1 is connected...

josedunet · 12-23-2009

Hello,I wonder if there is software like Packet Tracer somewhat more advanced that contains the swit...

josedunet · 12-10-2009

thanks naikumar,How can i load balance the traffic to Internet ?Best Regards,

josedunet · 12-10-2009

hello all,How to configure the automatic failover between two connection (access) internet in cisco ...

josedunet · 08-13-2009

Please, how can i configure the ip nat outside in the internet interface?

josedunet · 08-13-2009

Thanks.

josedunet · 08-13-2009

Hello All, I have an smtp server at 10.10.10.3, located behind my cisco router 831 whose inside glob...

josedunet · 07-09-2009

Thank you Collin.

josedunet · 07-09-2009

Hello, I would like authorize the access in the internet since a cisco router 1760 with according to...

josedunet · 06-15-2009

Ok. Just like that, could you advise me a billing software which works with CCME and can allow me to...

Re: Cisco Unified CallManager 4.2(3) license