s.arunkumar

Hi Since the switch is a layer 3,just create an svi for each vlan,and give one ip corresponding to e...

Hi Is your internal network a flat network??,ie no vlan etc.As per the configuration and diagram u g...

Hi mike I am really confused with ur scenario and requirement !!!!!! maybe b'cas of my inexperience....

Hi Just remembering read somewhere that "locally originated traffics are processes switched"..but ur...

Hi 1.As mentioned in earlier post the root guard is used when the port should not become a root port...

Hi what error are u getting..I think the command is not correctits "ip route 0.0.0.0 0.0.0.0 10.160....

Hi Daniel, As far as i know multiple match statement inside a route-map uses logical AND.Hence all t...

Yes ,tagging is needed..LAN QoS uses ClassOfservice(COS) bits for qos classification and marking.The...

Hi "switchport protected" command will do the job..Configure this on each of the ports which u dont ...

Hi, The static entry is prefered over ospf as said earlier.ospf will take over only if the AD of sta...

HiFor the same route(ie,with matching subnets) if u have both static and ospf,then static will be pr...

Hi mike,Yes,router on stick will defeat the purpous of 4500.....Why is there a connection directly g...

Hi mike Its good u finaly came up with a diagram.. :)I am not able to understand the requirement pro...

Hihttp://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hiad_c/ch15/index.htmHope th...