s.arunkumar

Any link state changes generates lsa reflecting the changes,and that will trigger an spf calculation...

Do u mean to say it calculates every two min?Normaly an spf calculation is triggerd when a change in...

hi sai, Since you dont have a specific routes towards destination (ie,only default route)i think wor...

Hi sai, Now what nikhil said is correct for incoming traffic . Yes u can adjust local preference for...

Ok so that was done as the default route cannot cross the firewall... Now can u check once again the...

If u want load sharing u need to give "maximum-path 2" command.Even a better configuration i suggest...

That was a good point by shrikar..Now also check ur configuration..u have configured the network 2.2...

I would like to let you know as the above posts says,DR/BDR has nothing to do with how the routes wo...

Hi1. Weighted fair queing(WFQ) is flow based ,ie classification is done for a flow.whereas,CBWFQ is ...

The default gateway is given as IP on a layer3 device.Now the switch may be a layer3 switch.Hence gi...

To add to above..here u should also remember that the router which comes first will become DR and th...

OK.. :(Can u just provide with the config and routing table and bgp table outputs of the routers..ar...