HiWe are getting around to replacing our ACI switches. These are 1st gen switches and we are replacing them with 3rd gen switches. I've seen and read through the "Upgrading the Switch Hardware" guide at https://www.cisco.com/c/en/us/td/docs/dcn/aci/a...
HiWe are about to go through a company merger and looking at creating a multi-tenancy environment within our ACI infrastructure. Currently we only use 1 tenant (in addition to the common, Mgmt and Infra tenants of course), where we have a VMM domain ...
HiI wanted to share an issue I've had with OSPF and Catalyst 9300 switches. I would like to know if anyone else has seen this or not?We recently purchased 2 * Catalyst 9300-48UXM switches. Switch1 has C9300-NM-8X card installed and network advantage....
HiI am trying to set up PBR on a Nexus 7700 with nxos 8.4(2). The policy does not appear to take effect. I see no traffic going down the link and I see no hits on the ACL or route-map. I have used PBR on IOS devices and routers but this is the first ...
Hi I have noticed the following error being logged on a Nexus 7700 switch: %MODULE-4-MOD_WARNING: Module 5 (Serial number: JAE20470361) reported warning Ethernet5/25-28 due to single-bit ECC error in device DEV_CLP_L3 (device error 0xcaf06600) The er...
SergiuThere are no errors in the logs for the that time period. If run show route-map pbr-statistics, it does not show anything route-map X, permit, sequence 10Policy routing matches: 0 packetsDefault routing: 0 packets ThanksRoy
Hi Sergiu I don't have Advanced Services. We have LAN_Enterprise_Services, which according to the licensing guide, https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx-os/licensing/guide/b_Cisco_NX-OS_Licensing_Guide/b_Cisco_NX-OS_Licensin...
The bug report is interesting, although I am running nxos v.8.4(2), which is later than the fixed versions referred to. I have reloaded the module with no change. Due to vast amount of errors being logged, I have to lean towards this being a hardwar...
Hi MarinI had not come across that particular bug report. That does seem to be have been the problem. It looks like that has worked.- I left the ROMMON on 17.3(1r). I- then upgraded the HW programmable devices, with 16.11.1, although it only upgrade...
LeoThanks for the reply. Good to know about the ROMMON inconsistency.I did attempt the firmware upgrade before I upgraded the ROMMON from 16.3(2r) but it failed and I saw the same memory errors. This is why I upgraded the ROMMON to 17.3(1r). I will a...
