getaway51
Level 2
Level 2
Member since ‎11-14-2016
‎11-15-2023

User Statistics

  • 361 Posts
  • 0 Solutions
  • 10 Helpful votes Given
  • 31 Helpful votes Received
Recent Badges
 30 Helpful Vote
10 Helpful Vote
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

May I know does bandwidth and queue-limit affect WAN MPLS cct performance 80Mbps?Why does  bandwidth configure under class VIDEO is 1024, wht it means to WAN circuit bandwidth of 80Mbps? Bandwidth for class-default is 2048. Does it means bandwidth wi...
Hi, I have a voice device. It connected to a voice vlan. But there is no "int vlan 10" in the config. However it is getting IP from vlan 1. When "sh mac address-table", it falls under vlan 2. But "sh ip arp", it falls under vlan 1.May I know what is ...
Hi, May i try to understand wht these prepend command means in layman term?Why adding ip prefix-list Prepend-list-1 and ip prefix-list Prepend-list-2 below?   R1274-R1no ip prefix-list Prepend-list-1 seq 1 permit 10.17.5.0/24ip prefix-list Prepend-li...
hI, It seems the Radius DEAD and ALIVE logs were occuring every few minutes. User complains it affect their access. However I thought when AAA down, all hosts will be AZ (authorised)? It seems AAA servers intermittent reachability frm the switch affe...
Hi, I am trying to configure primary and secondary route with pref 1 and 2.The objective is to always use primary route gateway 10.1.1.1. and Only use secondary gateway 10.1.1.2 if primary is down.On top of tht, I also have a default route 0.0.0.0/0 ...
Community Statistics
Member Since ‎11-14-2016 07:38 PM
Date Last Visited ‎11-15-2023 05:03 PM
Posts 361
Total Helpful Votes Received 31
Helpful Votes Given To