jack
Level 1
Level 1
Member since ‎01-20-2011
‎08-18-2017

User Statistics

  • 20 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received

User Activity

Hello,I have two switches running updated IOS's.  They are both 3560's.  On one of them the "dot1x auth-fail" setting is available on the other one it is not.HERE IS SWITCH #1 :Switch Ports Model              SW Version            SW Image------ ----...
Our company has recently purchased a second (much faster) internet service solely for the use of the IT Department.I am trying to set up the following:IT Deptartment (VLAN 55 - 192.168.55.0) has access to:     LAN     Internet Through the NEW ISPRest...
Hello,I have a Cisco 861 router and I do not appear to have any ipv6 commands available.  I am using config file c860-universalk9-mz.150-1.M3.bin - from JULY 2010.  When I read the release notes for the 15.0(1) M3 releases, it appears that ipv6 is a ...
My goal is to configure Cisco IOS to act as a filter for what website destinations will and will not be accessible by internal clients.The problem is that when entering an extended access list using a hostname you get the following:CZX800#conf tEnter...
Hello,I set up a site to site VPN in my lab with these two routers and it worked.  The setup looked like this:1720 e0 ------------- switch ---------------- f4 861The outside interfaces were e0 and f4 respectively.  Their IP addresses were mirrored in...
Community Statistics
Member Since ‎01-20-2011 09:06 AM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 20