Hi all,I have a pair of 5512-X's with IPS. The ASA's are configured for failover with active/standby. Is it possible to configure the 5512-IPS is an active/standby state with configuration synchronisation? I’ve been unable to locate any configuratio...
Hi,is it possible to use a Wireless range extender with a WLAN installation of LWAPs & WLC?Is there a security setting in the WLC that prevents multiple clients connecting through the range extender?Any advise would be appreciated.Regards,Chris
Hi,We have just installed Cisco Mobile 8 on two iphones. Dialing out work fine however only 1 in around 10 incoming call cause the phone to ring normally, for all other incoming calls the iphone rings once and then stops. The call continues to ring o...
Hi all, I have CUCM Business Edition 6.1.4 Our Backup's (configured within Disaster Recovery System) have been failing for weeks and we have only just noticed. I would like to enable email alerts for successful and failed backups - is this possible? ...
We've had a CSS11501 installed for around 18 months. In the past 8 months we've had three occurrences were we loose IP connectivity on the uplink from the CSS to a Cisco 3560 however nothing has changed. When the issue occurs we are unable to ping th...
I had similar issues to you. My inside network is 172.16.22.0/24, and my management network is 192.168.1.0/24. The ASA had 192.168.1.1 and the IPS had 192.168.1.2 on the management interfaces. The IPS needed to access the internet for global correlat...
Hi,thanks for your response.Logging console is already disabled.With regards to IOS upgrade - I only want to do this if I know there's a good reson to do it.Regards,Chris
Hi,thanks for your input however thats not the problem. 201.196.128.56 isn't an address on the router, it only has one IP and its 192.168.15.10.The 201.196.128.56 address is the NAT'd address on the firewall. So that when a SIP call is made to the in...
