AnyoneIs it possible  for a Cisco 3750e with Cisco  X2-10GB-LX4 to link to a Cisco SFP-10G-LRM in a  4507R+E. The  intermediary Fibre is OM3 50 micron. Switches are Approx 70Mtr Apart.Or is there any known issue which would prevent a link establishme...

I have a Cisco 3745 router with 48Digital Modems and 2 x E1 interfaces E 1/0 and E 1/1 i have configured for 1 Pri Circuit to Dail out (E 1/0) and the other to dialin (E 1/1).I have configured the lines 65 - 94 for dialout and dialin line 97-117 . Ho...

I have configured a Cisco 3745 for both Dialin and out connectivitythe configuration is, an application server designed to communicate directly with RS-232 com ports with attached modemswill utilising an IP based software offering virtual com ports w...

I am looking to replace a bank of standalone dial in/out modems with a router and Digital modem configuration, Where i need assistance is how i might configure the Cisco router to communicate with a multiport serial adapter in a server. The Current m...

Recently during an IOS upgrade there was a power failure which resulted in the loss of the IOS and booting to Rommon. There was a bit of playing with registers and eventually the image was replaced using Xmodem and rebooted. Since then the route...