I have a question about 802.11n settings. I have the default radio channel set to 11 and the channel width set to below 40 MHz.Is this correct or should the channel width be set to above 40 MHz?I'm finding a large number of receive CRC errors. Should...
Hi, I created a second VLAN and a second SSID. My problem is that from a PC on the native VLAN 1 I can ping the IP of VLAN 2 192.168.2.254 but I cannot ping any other device that has connected to the second SSID.How do I get routing to work between t...
Hi, I have a 887W and would appreciate help sorting out a NAT question.interface Dialer0description $FW_OUTSIDE$ip address 165.228.87.236 255.255.255.0ip nat outsideip virtual-reassemblyzone-member security out-zoneip nat inside source list 100 inter...
Hi, I would like to know how to get 4088 byte jumbo frame support on the four LAN 10/100 ports. This is a ADLS2+ unit, so it would need to have MTU 1500 on the WAN port.Any help greatly appreciated.regards, Mark
Hi, I have just replaced my pix 506e with a 887W and I have set it up.My secondary DNS which is outside my network cannot get updates from the primary nameserver which is inside my network.The CCP firewall page allows me to choose dns and inspect, bu...
In Australia. I will sell when I buy a new unit. There does not appear to be a cisco product that is reasonably priced and fits my needs. I will have a look at linksys but probably one of the other brands.thank you for your help today. gotta go out ...
thank you for clarifying the matter. I will purchase another device and throw the cisco in the bin. I have slowly whittled away at reducing cisco devices (primarily because of the excessive cost and poor performance) and this is justification to get ...
To be clear my network has jumbo frame turned off in all devices due to the 887W being incompatible.I have friends who have the same desktop wireless cards and achieve 180 Mbps or higher. The difference is they have draytek, billion or other ADSL2+/r...
I do realise that 300 Mbps is a theoretical max. What I was trying to say was that I would expect to get about 150 Mbps or more.I have connected the NAS to the FE ports in the past - but of course being FE there is no jumbo packet - another feature...
If I connect the desktop to the GB switch I get 50 MBps file transfer.The desktop is using wireless and I'm now getting 4 MBps that is about 35 Mbps - a long way from 300 MbpsApart from the person next door having an AP on channel 6 there are no sour...
