About jawicks

jawicks · 04-13-2016

I create a new device under a given project via an API post to "/pnp-project/{projectId}/device" and I also need to specifiy the JSON format config-template which goes with that device for PnP. The API documentation states that I should specifiy "con...

jawicks · 03-16-2016

Hello, I am trying to add a new WiFi Access-Point into a previously provisioned APIC-EM project via the REST API using post method to the URL below (the x-auth token-id and project-id is good because I can read the list of devices within the project)...

jawicks · 06-05-2015

The following devices have passed the OpenReach MCT testing process or have been given a pass status based on their similarity to other models which have already achieved a pass (indicated with "=" in the pass-date column below). This table will be u...

jawicks · 12-04-2020

Nothing planned for Annex-M at the moment................if you can reach out to your usual Cisco account-team and ask them to ping me with the details, then we can weigh the merits of getting them passed through the OpenReach certification process,...

jawicks · 11-30-2020

It's kind of neither of the two scenarios you give, probably ends up being closer to the second option.............the "bandwidth remaining percent" configuration tells the scheduler the amount of bandwidth to allocate to that queue after all the pr...

jawicks · 11-30-2020

If you shutdown the BVI interface of the HSRP-Active device then you are not going to see the standby transition into the Active state from that same device where you have just shut the interface, because you have disabled the interface over which it...

jawicks · 11-30-2020

Try changing your egress policer to a "flat" policer so the config looks something like the following and then check the packet matches on the PPPoE session once it has been re-established with the revised config. policy-map 10240kb class class-de...

jawicks · 09-23-2020

Hi Carlos, yes you should be able to do this as part of your PnP Python script using the urllib module and at the end of your script once a routable IP-address and other identification has been provisioned which initiates a post-operation toward your...

Member Since	‎05-17-2003 03:45 AM
Date Last Visited	‎04-23-2021 07:11 AM
Posts	23
Total Helpful Votes Received	33

User Statistics

User Activity

Listing configID

PNP device provisioning

BT Openreach VDSL MCT Certification - CPE Pass List

Re: BT VDSL MCT Certification - CPE pass list

Re: QoS Child Policy Bandwidth Allocation

Re: Configuring HSRP and VRF in EVC model L2VPN XR

Re: QOS seems to not be enforcing on BNG.

Re: Using EEM (w/Python, Tcl, etc.) to Call an External API (REST)