Everyone, First, here is the setup: 2 6500's with dual Sup 720's connected together with dual Gigabi...

I need to setup a QoS policy-map on a 3640 running 12.4(17)and cannot figure out 1 small piece. Here...

I got a 3640 with 2 FastEthernet interfaces and a Catalyst2900XL which provide connectivity through ...

This is the wrong forum for that question as you are knee-deep in VOIP-land with that question. I wo...

Yes, there are always people who ignore policy, but a good LART deployed early and often will quickl...

Like the other poster said, packeteer makes some things that will fix this. Also, forcing HTTP and F...

I manage a 150-AP wireless network running the 4.0.219 code with WLC 4400 controllers and 1242 AP's ...

Don't do, PLEASE don't do it. Been there, done that. One issue you will run into is that Nortel does...

One other small point is that using shielded cables counter-intuitevely means your maximum distance ...

Ther is a very bad bug in the Nortel LLDP firmware, fixed in an upcoming release. I had to push Nort...

First, your network team is actually getting you to do a Very Good Thing. BPDUGuard prevents idiot u...

The answer is "it depends" :-)I would not say any particular config is optimal though. If you have a...

1) Make sure IAS allows EAP-MD5 as an authentication method (I am using ACS so I can't help you much...

I found a link to an "Ask the Expert" post that addresses these issues.Basically this fall Cisco is ...

Hmmm, I have tested this in a lab and it works fine.... with a big caveat that makes it not almost n...