cplatt01

No confusion! I always appreciate other angles to attacking a problem.CHRIS

Cool...glade we are on the same page....I will give it a try.CHRIS

It doesn't appear that the settings in the Routelist offer any diffierent options than on the gatewa...

Thanks for the information. I have checked to make sure that the following is set:"Calling Party Pre...

I have a user who wants to forward his phone to his cell phone. Normally this would be no problem.Ba...

I have a user who wants to forward his phone to his cell phone. Normally this would be no problem.Ba...

A few notes:1) I would do this after hours2) Pull the Call Manager that you are changing out of the ...

Agreed...that is what I did. I can't believe that this happened...surprised by Cisco...

I am running 6.1.2.1002-1

Same issue here, and I applied the latest firmware to my phones as well as reset NTP.

Okay, I thought the gateway would register even if the endpoint would was not available with MGCP. T...

Nick,1) Correct2) NO layer one is still down (I don't think they connected the E1 line, but I didn't...

I have an issue that I have not seen before. I have the E1 PRI interface showing registered, but whe...

6.1(2-1000). The strange thing is it only happens on 1 phone.

Thanks Rob. I checked both of your suggestions, and both are good. The strange thing is that even wh...