I have a UC520. We just upgraded from a 6Mbps bonded T1 connection to 100Mbps fiber connection. We I run a speed test, I only get about 25Mbps. When I disconnect and plug up a laptop straight to it, I get the full 100Mbps or close to it. Does the...
i have a UC520. i recently upgraded software pack to 8.2.0. i received the typical auth fail message so i performed a factory reset of the phone. now it shows that it is trying to upgrade but remains at 0K when downloading term75.default and moves...
I have a UC520 that I upgraded to software pack 8.1.0 last night. We have all FXO lines incoming. Call comes in and receptionist answers. Then when she hits transfer, call goes to MOH, and when she hits extension number, call is dropped. Caller g...
I have a UC520 with 7965 phones. One of my phones lights up when plugged in but does not function. Only the speakerphone button is lit and I have tried a hard reset on it to no avail. Is the phone dead or is there something else I can try to get i...
I have a client with 2 locations. One has an older UC520 system and they have now expanded and we are putting in a new UC540 at the new location. I have a SA520 to go in front of the UC540. I was going to connect the 2 systems but was looking for ...
Scott,I too have a couple of multisite configurations in which i have set up extension ranges to be different. however, i am not as well versed as you in CLI to have the systems just dial 3 digits. i have:Site 1 - 100-199Site 3 - 300-399Site 4 - 40...
Thanks for your response. I guess you'll have to be a little more specific. I am not a CCIE with 20 years experience. I don't know, nor understand what you are talking about. All I know is that I have a Fast Ethernet connection on the WAN and it ...
No, GP, the phone has no firmware at all on it now. Just reboots and tries to pull it and fails. I am now catching a glimpse of the "Auth Fail" message when it fails. Should i try and load the 8.5.2 firmware on the system and see if it will compl...