AdamF1

That bug also states its resolved in the version he is running ( 16.9.6).

Are you saying you did not find that setting on your controller after upgrading?

Username is sensor. PW Is password 

There are creative ways around this.. one issue you will face is the the 9800 and 55xx lines run 2 d...

I’m just as confused about the topology as the others. you stated you plugged directly into the 35xx...

I run Netflow fine on my 16.9.x switches. on your recordadd collect timestamp absolute first and las...

LACP or if it’s a routed port channel then you can do them as p2p. 

I use the emails events for this. I subscribe to the AP down and when it’s resolved it sends an emai...

Are you able to share the TAC case # for the 16.12.5 poe issue?

Did you open a Cisco Case? Bug CSCvv50628 states it was resolved in 16.12.5. Anyone else have POE is...

Oh I have been letting our SA know... At this point I don't think 16.12.x will be a functioning IOS ...

Why would it need to support CDP or LLDP?

Look at the bug Id above, it has the link to it and the work around. other work around is upgrade

Try this one from skyline as itsthe foundations of building stuff out in it. https://catalog.skyline...

I haven’t had luck with non Cisco power adapters. You could buy a cheap dumb switch that does POE su...