About Ben Rodriguez

Ben Rodriguez · 05-22-2019

I am planning a new CUCM environment with an ITSP that will connect via a CUBE. CUCM <-> CUBE <-> ITSP, it looks like I will need the CUBE-T-RED license. The two questions I have are do I need 40x licenses per HA pair for 40 trunk sessions? My resell...

Ben Rodriguez · 12-07-2018

Hello Support Community, I'm trying to figure out how to configure the ports on a Cisco SG200-8P for data and voice vlan. Whereas, the enterprise grade equipment offers command line and does not require any fiddling with GUI, I'd like to accomplish s...

Ben Rodriguez · 10-30-2017

Hello, We are trying to figure out the best method for failing over to providers if one is down. We have CM 11.5 with a SIP trunk to a pair of 4K routers in HA. The users calling number are using their DID. The issue I see is if their ITSP (ITSP-A)...

Ben Rodriguez · 06-21-2017

Hi community, In the upgrade guide for CER it says you need to upgrade CER first. Is that a hard requirement? Does anyone know whey that is? I thought CER was an auxiliary component. You must upgrade Emergency Responder before you upgrade Unified C...

Ben Rodriguez · 03-20-2017

Hi all, I am setting up a 3 node CM and 2 node IM&P environment. I am looking to figure out how to get the SRV records setup properly for the integration. I have the SRV records created but I'm not sure how this should be done properly. The document...

Ben Rodriguez · 05-22-2019

Thanks everyone. Both replies were helpful. They confirmed what I was thinking

Ben Rodriguez · 05-13-2019

Hi Mike, I have. We are a MSP and a Cisco partner. It's a lot of infrastructure to stand up for my needs. I would like to build and manage it myself. VMware Cloud looks like a good fit, Webex Calling is limited and HCS seems to be a big undertaking. ...

Ben Rodriguez · 07-26-2018

I can confirm it doesn't route via the routing table. The default behavior is not scalable. I would like to not have to pin it to an interface so I can still use TACACS+ when the primary interface or ISP is down. The command will not take if your TAC...

Ben Rodriguez · 06-13-2018

In that range the .0 and .1 are in the same /31 using a .0 seems crazy but since you don't have a network and broadcast address that is how it works.

Ben Rodriguez · 01-05-2018

Excellent guide. What license level do we need for using the Anyconnect NAM Client on ISE?

Member Since	‎10-21-2010 01:53 PM
Date Last Visited	‎05-29-2019 06:36 AM
Posts	33
Total Helpful Votes Received	15

User Statistics

User Activity

New CUBE License question CUBE-T vs CUBE-L

Cisco SG200 Data and Voice Vlans

ITSP failover between SP's from CUBE

CER and CUCM upgrade from 8.6 to 11.5

IM&P to CM Integration question - SRV records

Re: New CUBE License question CUBE-T vs CUBE-L

Re: Any production VMware cloud Collaboration user out there?

Re: Hi Hermant,

Re: when and why we use /31 subnet

Re: How To: Deploy EAP Chaining with AnyConnect NAM and ISE