Hello,Is there an issue to run powertool with powershell on Linux.I installed powershell on RHEL, and I try to run cmdlet from UCS Powertool, but it doesn't work.I copied Module directory from Windows into Modules directory on Linux (in to /opt/micro...
Hello, since i upgrade my central in 1.3(1a) I have a pb on clock of UCS Central, not for clock in domain definition.In GUI I defined TimeZone "Europ/Paris" in "Administration", "General" (old GUI). But this GUI and CLI show a PDT clock not CEST as b...
To check compatibility between our Cisco MDS 9000 and UCS Manager, is there a correspondence table betwenn the UCSM versions and the NXOS versions inside ?Example : the last UCSM 2.2(1b) contains nxos 5.2(3).It seems this nxos version is not compatib...
Hello, I finding a old fault, which has been cleared of the faults view. I don't see it in Events view. How finding a old fault ?Thank for your help.Stéphane
Hi,In Internal LAN section, I have a port-channel with no members. When I try to delete it with GUI, I have an error "Port channel cannot be deleted". With CLI, I only can delete member, but I have no members.Thanks for help Stéphane
Hello Sumanth,Thank you for this information.StéphaneDe : Sumanth B R Envoyé : mardi 20 décembre 2016 04:47À : Tailpied StephaneObjet : Re: - powertool on LinuxCisco Communities <https://communities.cisco.com/>powertool on Linuxreply from Sumanth B ...
Hi,
After "debug hardware internal carmel clear-counters error", does it make a reset of IOM ? because I have always the CRC error in GUI, in fabric ports of IOM chassis.
How can I have the CRC counter of theses fabric ports in CLI interface, becaus...
