About sasha

sasha · 02-28-2024

Hello. Do Catalyst switches log all supported messages by default (with regard to the logging level and discriminators), or is there a way to turn some messages on? To be specific, some of our Catalyst switches log these messages when a user logs out...

sasha · 02-20-2024

Hello. Can passwords be extracted from an FMC backup, if an unauthorized person obtains a backup file? Thanks and best regards.

sasha · 07-24-2023

Hello. Is it possible to create an ACL on Firepower which gets IP adresses to block from a network feed? We have a custom network feed, auto-populated on a given number of failed RA VPN login attempts in a time interval. The feed is on a RADIUS serve...

sasha · 04-26-2023

Hi. Config guide says ASA should pass PIM-SSM through when it's not LHR. Are there any commands to enable that? I see packets from source to 232.x.y.z in capture on the incoming interface (outside), but not on the outgoing (inside). ASA version is 9....

sasha · 03-30-2023

Hi. One of my AIR-AP1852I stopped working, and it displays just a few messages on the console: U-Boot 2012.07 (btldr release 38) (Oct 29 2019 - 06:39:45) This product contains some software licensed under the"GNU General Public License, version 2" pr...

sasha · 03-06-2023

I've just edited the topic title ("modify" -> "increase") to avoid such misunderstandings. BR.

sasha · 03-06-2023

Dear Marvin, with all respect, confirming both You and @balaji.bandi didn't see the following sentence in my initial post: > I'm NOT talking about "set connection decrement-ttl" . I need to increase TTL, not decrement it... Any ideas? Thanks and best...

sasha · 02-28-2023

Hi. I know the document, but as far as I see, it doesn't say anything about the feature I need. Any other ideas? Meanwhile I've found this topic which mentions Multicast Service Reflection (MSR) on IOS routers: https://community.cisco.com/t5/routing/...

sasha · 06-23-2022

So folks, thank you both for help. The first policy went fine. Here's the outcome: - Before I assigned the first flexconfig policy to our FTD HA pair, Preview Config button was grayed out. - But after I assigned the policy and before I saved the chan...

sasha · 06-22-2022

So, it would be sufficient to compare "show run all" before and after new FlexConfig policy, assuming there are no other changes in the same deployment?

Member Since	‎07-15-2005 12:27 AM
Date Last Visited	‎03-20-2024 12:30 AM
Posts	50
Total Helpful Votes Received	5

User Statistics

User Activity

Turning on log messages on Catalyst switches

Can passwords be extracted from FMC backup?

Network Feed in an ACL on Firepower

ASA PIM-SSM doesn't pass through

Aironet 1852i not booting

Re: Can ASA modify TTL of packets it forwards?

Re: Can ASA modify TTL of packets it forwards?

Re: Can ASA convert multicast to unicast?

Re: Default FlexConfig Policy?

Re: Default FlexConfig Policy?