About mistryj

mistryj · 03-20-2017

Hello, I need some help configuring a routing scenario below on the ASA Firewalls only between sites A and B as per diagram (see attached. It can be done using BGP or OSPF but need guidance on which is the best and simplest to configure and how it ...

mistryj · 05-11-2016

Hi All, I am having issues with inbound access from network 200.200.10.0. Outbound traffic from 10.10.10.0 is working fine to 200.200.10.0 via NAT IP 193.50.50.103 I have attached config. Any ideas ?

mistryj · 04-23-2016

Hello, I have attached a diagram. I have two sites with dual ISPs one MPLS and other Internet VPN tunnel connecting between them and VPN tunnels to C.D,E,F. Routing protocol EIGRP for all sites. BGP only running over MPLS and EIGRP on LAN side on...

mistryj · 01-18-2016

Hi, I have a Cisco IOS router and want to setup an IPSec tunnel between myself and client. Unfortunately we both have overlapping 10 network IP addresses. Is it possible for me to just Nat the IPs on my side or does the client need to Nat as well ? ...

mistryj · 01-08-2014

We currently have a collapsed Core design with 6x 6500 Core switches distributed with WAN links to 2 data centers. Cisco 3850 User Switches connected to cores in main building. VM Enclosures and Servers connect directly to 6500 switches at Data Cente...

mistryj · 05-19-2016

Hi, Yes unfortunately this did not help VMware does not like NAT. I had to remove NAT completely and change my peer network. Thank you !

mistryj · 05-13-2016

Hi Sheshu, OK I will try this and come back with update.

mistryj · 05-13-2016

Hi Sheshu, Yes but I cannot ping from 200.200.10.10 Server to Servers on 10 network ? What change do I need to make ?

mistryj · 05-13-2016

Hi, Yes typo I am not showing real IPs here it's 82.82.82.201 on VMware GUI I replaced. The Peer address is the Nated address as I am hiding 10 network behind the external NAT 193.50.50.103 If I remove the tunnel will complain and come up as MM_NOSTA...

mistryj · 05-12-2016

All, I am also attaching VMware screen shots with Router outputs above. No NAT, No Static Routes defined in GUI

Member Since	‎11-06-2002 07:17 AM
Date Last Visited	‎06-05-2018 10:55 AM
Posts	177
Total Helpful Votes Received	5

User Statistics

User Activity

Routing Scenario Configuration BGP/OSPF Question Help ?

ipsec vpn issue

Dual ISP + Hub & Spoke EIGRP Routing

IPSec tunnel and policy Nat

LAN Design

Hi,

Hi Sheshu,

Hi Sheshu,

Hi,

All,