Hello,
does anybody know what would be proposed solution for migrating IOS config below to IOS XR ?
IOS =>
vrf data
rd 10000:100
route-target both 10000:100
bgp next-hop loopback100
where loopback 100 is used for MPLS TE traffic routing (per VRF ...
Thank you.
These slides are a little bit more informative.
I tried to enter "rep stcn stp" command but it says :
Command Rejected: For Edge no-neighbor ports, stcn stp is allowed only if spanning-tree mode is mst
So it doesn't work. What if I ent...
Thank you.
I have found on ciscolive BRKSPG-2202, page 89 on pdf document that switch end ports should be configured as "rep edge no-neighbor". This is why I have some doubts. There is no straightforward config documentation for using REP-AG, or at ...
Hello Xander,
could you explain a little bit what would be correct configuration for REP-AG in a ring described in lower topology? We have 2 ASR9K on each REP segment end. REP admin VLAN is 96. REP segment is 201 carrying all vlans.
On switch por...
Hy,
it seems there is no such elegant solution, at least I cannot find it and I'm looking for quite some time. I don't understand why they didn't implement it in IOS XR. All sugestions I have seen are going in direction to implement some kind of ro...
Hy,
just to see another issue with this topic.
Let's say that we have Lo0 as global routing loopback and BGP router-id. And, we have Loop 100 for this TE purpose.
How to export from ASR and set next-hop ? I guess I can not do it inside global VRF c...