Trying to update a stack but the only tar file I see available also has the Web Based files and when I try to update the IOS with the archive-sw command all the html files are extracted too. Is it possible to only update the bin file without installi...
Hello,
I need to test ipsec config at DR site. Our L3 device uses BGP. I need to take one device and force it's traffic to our DR and not use the BGP route. Can anyone help me with this config?
Hello all!
I am in the process of trying to determine the best method for a secure backup connection over a public internet link. Right now our Primary is an MPLS via ATT with BGP. If that fails for any reaosn I'd like our branch sites to be able ...
Hello all. I was wondering if you ca help. I am trying to run a capture on our WAN interface for a certain IP. Every time I try to execute the command I receive "EPC configuration not permitted on standby"
ROPS-M0-A2-2-4500X-VSS#monitor capture MYC...
Hello all. I have an issue. IOS image was applied to the master switch and on reload the master switch will not come back up. I know the issue is the other two switches in the stack have an older IOS than the master. I disconnected the master from th...
Thanks for the response, Reza. I do see the bin file and have it. I am trying to update all 7 switches in the stack without having to copy over the bin file to each flash by using the "archive download-sw tftp://x.x.x.x/c2960x-universalk9-tar.152-4.E...
Thanks everyone for all of your help.
I don't believe BGP Backdoor would help me, unless I am not understanding something in the BGP Case Study link.
I have multiple devices that need to send traffic over the IPsec tunnel on our local firewall wh...
We have devices that need data routed out of our firewall and over an IPsec tunnel to a vendor. I am in the process of configuring our DR to be able to route this traffic to our vendor if our main site goes down. Right now our L3 device has BGP route...